Page 1 of 1

How To: Set up MPD to use a UPnP source [just a stub]

Posted: November 13th, 2014, 4:30 pm
by rhoering
Hi All,

This is currently a stub for "How To: Set up MPD to use a UPnP source"

What I currently know [and that is not much]:

1) Add the following to the mpd.conf:
neighbors {
plugin "upnp"
}

database {
plugin "upnp"
}
2) On my install [init.d based] I get an error when I comment out db_file.

Re: How To: Set up MPD to use a UPnP source [just a stub]

Posted: November 14th, 2014, 7:01 pm
by Rasi
but thats all there is to do. the plugin just works. (in recent versions)

Re: How To: Set up MPD to use a UPnP source [just a stub]

Posted: November 19th, 2014, 4:44 am
by rhoering
Thanks Rasi,

I need to circle back around on this. I installed the libupnp-dev, ran ./configure, make clean, make and make install but the upnp was not listed.

Ron